Starting/monitoring statin therapy
- exclude secondary causes of hyperlipidaemia e.g. diabetes, hypothyroidism, liver/renal impairment
- check baseline lipids, liver and renal function, creatine phosphokinase (CK)
- advise patient regarding medication e.g. adverse effects of statin treatment
- start statin treatment - statins should be taken in the evening for maximal effect, and require 4 weeks or more to exert their full effect on lipid concentrations
- LFT should be carried out before and within 4-6 weeks of starting statin therapy. Thereafter at intervals of 6 months to 1 year - earlier if clinical features of hepatotoxicity; also at the first review at 4-6 weeks - enquire about adverse effects such as itching, rash, myalgia, arthralgia, insomnia.
- if satisfactory lipid control and no evidence of adverse effects then review again at 4-6 months, then 6-12 monthly
- if unsatisfactory lipid control then measurements should be repeated 6 weeks after dosage adjustments are made until the desired lipid concentrations are achieved
- however NICE state that LFTs only need to be measured on three occasions:
- baseline liver enzymes should be measured before starting a statin. Liver function (transaminases) should be measured within 3 months of starting treatment and at 12 months, but not again unless clinically indicated
- people who have liver enzymes (transaminases) that are raised but are less than 3 times the upper limit of normal should not be routinely excluded from statin therapy
- treatment should be discontinued if serum transaminase concentrations rise to, and persist at, 3x normal range
- patients must be advised to report any unexpected muscle pain. Statins have been associated with the development of myositis, myopathy and myalgia. Some suggest if there is a marked elevation in creatine kinase concentration (>10 times the upper limit of normal) and a diagnosis of myopathy is suspected then the statin therapy should be stopped; however it has also been suggested that if the creatine kinase level is >5x the upper limit of normal then treatment should be stopped, while the patient is adequately monitored for muscular symptoms and cardiovascular risk
NICE guidance states:
- primary prevention
- offer atorvastatin 20 mg for the primary prevention of CVD (cardiovascular disease) to people who have a 10% or greater 10-year risk of developing CVD
- offer atorvastatin 20 mg for the primary prevention of CVD (cardiovascular disease) to people who have a 10% or greater 10-year risk of developing CVD
- secondary prevention
- start statin treatment in people with CVD with atorvastatin 80 mg. Use a lower dose of atorvastatin if any of the following apply:
- potential drug interactions
- high risk of adverse effects
- patient preference
- start statin treatment in people with CVD with atorvastatin 80 mg. Use a lower dose of atorvastatin if any of the following apply:
Reference:
Related pages
- Early monitoring of the effect of statins on lipid lowering
- Hypercholesterolaemia - primary prevention
- Hypercholesterolaemia - secondary prevention
- Interactions
- Protective mechanism
- Side effects
- Cautions/contraindications
- Statins
- Myalgia and myositis associated with statin treatment
- Reference range (cholesterol)
- Statin treatment - morning versus nighttime (night) dose
- Stopping statin prior to surgery
Create an account to add page annotations
Annotations allow you to add information to this page that would be handy to have on hand during a consultation. E.g. a website or number. This information will always show when you visit this page.